|
Are you looking for:
|
2 mm Pin Holder, Narrow, 90 deg., With Suction Port and Pellet
Compatible with any headstage utilizing a standard female 2 mm jack connector, this holder features a male 2 mm pin, a Silver/Silver chloride (Ag/AgCl) pellet, a suction port, and is made out of polycarbonate. The diameter of the main body of this holder is 0.25 in. Note that the connector is at a 90-degree angle relative to the glass pipette angle.
This holder can be manufactured to accept any size of capillary glass. If you would like to order a size other than any of those listed below, please contact us. |
Platinum Rod, Diameter 0.010 in., Nominal AWG 30, Length 3 in.
|
Female Pin Connector (fits Model 1800, Model 3000 Headstages)
|
Model 1800 2-Channel Microelectrode AC Amplifier, 220 V, 50 Hz
- Amplifier for metal microelectrodes
- Two amplifiers in one instrument
- Recording gain options: x100, x1000, x10 000
- Low noise (1.0 µV p-p typical, 10 Hz–10 kHz)
- High common-mode rejection ratio (110 dB at 60 Hz)
- High line frequency rejection with notch filter (>110 dB at 60 Hz) (50 Hz notch filter optional)
- High input impedance (100 000 MΩ)
- Low input bias current (±3 pA typical; ±20 pA maximum)
- Adjustable low and high frequency filters
- Power supply may be set for 110 VAC at 60 Hz or 220 VAC at 50 Hz
|
Knife Sharpening Kit (hone, strop, oil, 3 grades of abrasives)
|
Lamp, Replacement, EKE, 150W, Low Output, for 725900 or 725910
|
Bare Platinum Wire, Diameter 0.001 in., Nominal AWG 50, 10 ft.
10 feet (3.048 meters) per spool
|
Bare Platinum Wire, Diameter 0.002 in., Nominal AWG 44, 10 ft.
10 feet (3.048 meters) per spool
|
Axon Threaded Holder With Suction and Perfusion Ports and Wire
Compatible with any Axon headstage utilizing a threaded collar, this holder features a suction port, a perfusion port, a 99.99% pure 0.010 in. silver wire, and is made out of polycarbonate. The diameter of the main body of this holder is 0.375 in.
This holder can be made out of ultra-low noise fluoropolymer-based plastic for an additional charge. Please contact us for information.
This holder can be manufactured to accept any size of capillary glass. If you would like to order a size other than any of those listed below, please contact us. |
22 mm OD / 0.630 in. ID to 1 3/8 in. OD / 0.630 in. ID Adapter
|
